Dual AM505BT 사용자 매뉴얼

16

Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your
device before you begin the pairing process.

The AM505BT broadcasts the pairing signal constantly
when no devices are currently connected. Complete the
pairing sequence from your Bluetooth device. Refer to the
owner's manual for your device for more details.

Note: The AM505BT can be in any mode of operation
when pairing is performed.

If a device is currently connected, press and hold 

 

to

disconnect the current device before a new device can
be paired. Then begin the pairing sequence from the new
Bluetooth device.

Most Bluetooth devices support the auto-connect feature, and will connect automatically
if the device is in range when the AM505BT is powered-on. If your device was previously
paired but does not connect, use these instructions below.

• If your most recently connected Bluetooth device becomes disconnected or does not
   reconnect, press BAND from Bluetooth mode to reconnect your mobile device.

• To connect a previously paired device that was not recently connected:
1) If applicable, press and hold BAND to disconnect any connected mobile devices.
2) From Bluetooth mode, press SELECT. "Paired Devices" will appear on the LCD.
3) Turn the volume knob to cycle through the list of devices.
4) Press SELECT or BAND to connect to the desired device. It must be in range to connect.

Note: If the Auto Connect setup menu setting is set to OFF, you must press BAND to
connect you device after pairing, and each time the AM505BT is powered-on.

Press and hold BAND for 3 seconds to disconnect a connected device. The device will 
remain paired and appear in the SEARCH menu but will not be connected.