Dual AM505BT 사용자 매뉴얼
6
AM505BT
Press OPEN to open the face plate, then pull away from
the right side to remove. To re-install, insert right side of
faceplate first then push left side to secure.
the right side to remove. To re-install, insert right side of
faceplate first then push left side to secure.
Press
or any other button to turn the unit on. Press
to
turn the unit off.
Press SOURCE to enter the Source Menu, then press
SOURCE or rotate the volume knob to select between Tuner,
Auxiliary Input, USB, iPod, Bluetooth and Pandora modes.
Modes of operation are shown in the display.
SOURCE or rotate the volume knob to select between Tuner,
Auxiliary Input, USB, iPod, Bluetooth and Pandora modes.
Modes of operation are shown in the display.
The AM505BT uses the IP35USB adapter on the back of the
unit for connecting an audio device, MP3 player, etc. Refer
to the wiring diagram for connection instructions. Once
connected, press SOURCE to select auxiliary input mode.
unit for connecting an audio device, MP3 player, etc. Refer
to the wiring diagram for connection instructions. Once
connected, press SOURCE to select auxiliary input mode.
Adjust volume using volume knob (00-46).
Press DISP to toggle between ID3 tag and file/folder name
for MP3/WMA files being played from USB devices.
for MP3/WMA files being played from USB devices.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located behind the front
panel.
operation occurs. Reset button is located behind the front
panel.
The unit will display the time on the LCD display. Clock
settings are adjusted in the General setup menu.
settings are adjusted in the General setup menu.
The clock will display 12-hour AM/PM time or 24-hour time
(22:00). Frequency spacing is adjusted in the General setup
menu (refer to page 8).
(22:00). Frequency spacing is adjusted in the General setup
menu (refer to page 8).
Press to manually activate camera mode (camera wire will
supply power while this mode is on). Press and hold for
three seconds to activate Loudness settings (Low, High, Off).
supply power while this mode is on). Press and hold for
three seconds to activate Loudness settings (Low, High, Off).
Faceplate Removal
Power On/Off
Source
Auxiliary Input
Volume
Display
Reset
Set the Clock
12/24-hour Clock
Camera / Loudness
General Operation