ClearView HD2-PTZ-4 사용자 매뉴얼
3
2 Preparation Works
These series products support two control modes: Serial/HDAVS.
For HDAVS series product, please select control mode as HDAVS. The control signal is sent to the
For HDAVS series product, please select control mode as HDAVS. The control signal is sent to the
PTZ via the coaxial cable.
For the serial mode, the control signal is sent to the PTZ via the RS485 port.
2.1 HDAVS
Important
If you want to control the speed dome via the coaxial cable, you need to use the corresponding
HDAVS DVR.
Please go to the PTZ setup interface of the DVR and then set the control mode as HDAVS and the
protocol as HD-AVS. You do not need to set address and the baud rate. See Figure 2-1.
Please refer to the HDAVS series DVR user’s manual for detailed information.
After the setup, please connect the DVR to the speed dome via the video cable. Now you can control the
speed dome.
The device supports coaxial upgrade function, which is divided into two modes: quick upgrade and
general mode.
Note:
Storage device needs corresponding coaxial upgrade function.
Make sure the camera is directly connected to the storage device during upgrade.
Storage device needs corresponding coaxial upgrade function.
Make sure the camera is directly connected to the storage device during upgrade.
Figure 2-1
2.2 Serial
If you want to control the speed dome via the serial port, please set the control mode as serial. The
address, baud rate and parity value shall be the same as the dial switch of the speed dome. Otherwise,
you cannot control the speed dome.