NAD C 388 사용자 매뉴얼

The SR 9 remote control handset handles the key functions of the C 388 as well as other NAD Stereo 

Receivers, Integrated Amplifiers and Preamplifiers. It has additional controls to remotely operate NAD 

CD Players, AM/FM Tuners and dedicated AM/FM/DAB Tuners.  It will operate up to a distance of 

23ft (7m). Alkaline batteries are recommended for maximum operating life. Two AA batteries should 

be fitted in the battery compartment at the rear of the Remote Control handset. When replacing 

batteries, check that they have been put in the right way round, as indicated on the base of the battery 

compartment. 

1  POWER ON & OFF: The SR 9 remote has a separate ON and OFF button. Press the ON button 

to switch the unit from Standby to operating mode. Press the OFF button to switch the unit to 

Standby mode.   

SELECTOR: A Device Selector button determines only what component the SR 9 will 

command; it does not perform any function on the C 388.  Press desired Device Selector button 

for the applicable buttons to be directed to a “page” of commands relevant to the selected device.  

Upon selecting a Device, you can now press the corresponding SR 9 control buttons applicable for 

the selected Device.

SELECTORS: Refer to the corresponding labels printed in the remote control faceplate 

and their respective assigned buttons to make use of these functions. Set the DEVICE SELECTOR to 

“AMP” in order to gain access to these buttons. 

KEYS: The numeric keys allow for direct input of tracks for CD players, and direct 

channel/preset access for tuners and receivers.

5 SLEEP:  Switch off specific NAD Receiver or Tuner models after a preset number of minutes. This 

button control does not apply to C 388.

6 MUTE:  Press the [MUTE] button to temporarily switch OFF the sound to the speakers and 

headphones. MUTE mode is indicated by the Standby LED indicator flashing for NAD Integrated 

Amplifiers or “Mute” shown in the VFD of NAD Receivers.  For C 388, “Mute” is shown in the display.  

Press MUTE again to restore sound. Adjusting the volume level via the SR 9 or the front panel 

volume knob will automatically release the mute function.

5/6:  Toggle through the source input selections. If the optional MDC modules are 

installed, the source selections will include the sources incorporated in the applicable modules.

8  DIM (for use with NAD Stereo Receiver, Tuner and CD Player): Reduce, turn off or restore VFD 

brightness. Depending on the NAD model, the brightness of the front panel display will vary when 

you toggle this button. For C 388, toggle to vary brightness level of the display - brighter, normal or 

dimmer (not applicable if current dimmer setting is “Temporary”).

OPT 1

OPT 2

COAX 1

COAX 2

PHONO

LINE 1

LINE 2

USB

BT