PSB CS500 사용자 매뉴얼
3
Thank you for your purchase. Our speakers are designed to make high-performance sound easy
to bring into your life. They have wide frequency and dynamic range, natural tonal balance and
precise spatial imaging needed to make music lifelike and enjoyable.
to bring into your life. They have wide frequency and dynamic range, natural tonal balance and
precise spatial imaging needed to make music lifelike and enjoyable.
I. SPEAKER PLACEMENT—MAXIMIZING YOUR ENJOYMENT
In most installations, ideal speaker placement relative to the listening positions and
surrounding areas can be difficult to achieve. However, following as much as possible, the
guidelines listed below can greatly improve the final sonic effect, lower the expense and
simplify the installation.
surrounding areas can be difficult to achieve. However, following as much as possible, the
guidelines listed below can greatly improve the final sonic effect, lower the expense and
simplify the installation.
Consider the desired and probable locations of listeners when deciding on speaker
placements. As much as possible, listeners should have a clear line-of-sight/hearing to all
speakers in their listening area. Other important factors are:
placements. As much as possible, listeners should have a clear line-of-sight/hearing to all
speakers in their listening area. Other important factors are:
1. Locating speakers equidistant to listeners.
2. Locating speakers slightly closer to each other than their distance from listeners.
3. Locating speakers symmetrically to each other and to the listeners.
4. Aiming speakers slightly above the listening area—the speakers have been voiced
2. Locating speakers slightly closer to each other than their distance from listeners.
3. Locating speakers symmetrically to each other and to the listeners.
4. Aiming speakers slightly above the listening area—the speakers have been voiced
to achieve enhanced coverage in open spaces.
5. In horizontal installations locating the tweeters towards the outside of the
listening area.
Balance adjustments on the amplifier can compensate for some physical location
differences between the left and right speaker.
differences between the left and right speaker.
Mounting/locating a speaker in a corner, near the ceiling or under the soffit and similar
single or multiple boundary surfaces will increase the bass output. For full bass extension
in addition to placement, the Port Plug should be removed from the port (if applicable).
However, under extreme weather conditions, the Port Plug should be inserted to protect
the speaker.
single or multiple boundary surfaces will increase the bass output. For full bass extension
in addition to placement, the Port Plug should be removed from the port (if applicable).
However, under extreme weather conditions, the Port Plug should be inserted to protect
the speaker.
II. MOUNTING
THE
SPEAKERS
Select corrosion resistant fasteners (eg. made of stainless steel) of sufficient quality and
size, appropriate for the surface to which the speakers will be mounted, to ensure secure
mounting with good safety margin.
size, appropriate for the surface to which the speakers will be mounted, to ensure secure
mounting with good safety margin.
It is your responsibility to ensure that the surfaces selected for attaching the speakers are
structurally sound and strong enough to bear the weight of the speakers. Consider using
#10 - #12 (5.0 or 5.5mm) screws that are 2.5 to 3” (65 to 75mm) long for direct-to-wall
stud attachment or specialty anchoring hardware for hollow-wall or masonry installation.
It is strongly recommended to use Steel Cable for tethering the speaker to the mounting
surface. The cable should pass through the Cable Guide and wrap around the Aluminium
Bracket as shown in Figure 2.
structurally sound and strong enough to bear the weight of the speakers. Consider using
#10 - #12 (5.0 or 5.5mm) screws that are 2.5 to 3” (65 to 75mm) long for direct-to-wall
stud attachment or specialty anchoring hardware for hollow-wall or masonry installation.
It is strongly recommended to use Steel Cable for tethering the speaker to the mounting
surface. The cable should pass through the Cable Guide and wrap around the Aluminium
Bracket as shown in Figure 2.