MINOLTA DiMAGE 2330 사용자 가이드

• While this camera is connected to the computer or transferring the image data

between this camera and the computer, do not perform the following
operations. Otherwise, the error may occur, the camera and the computer may
not function correctly, or the image data recorded in the CF card may be
erased or damaged.
• Turn off the power of the camera
• Disconnect the USB cable
• Rotate the function dial
• Remove or insert the CF card

• When disconnecting the USB cable, be sure to confirm that the focus lamp

(green) does not light or blink, and perform the procedure described on pages
from 140 to 141.

Especially for Windows

®

2000 Professional, be sure to confirm that the access

lamp of the hard disk does not light (it does not access to the hard disc) and
perform the procedure described on pages from 140 to 141

On Windows

®

2000 Professional, the data transfer is not actually completed due

to the delay of writing even when the display on the computer shows that
copying is finished. As the data is transferred for a while even after the copying
message disappears, do not turn off the power of the camera, disconnect the
USB cable or rotate the function dial during the time. Otherwise, the error may
occur, and the camera and the computer may not function correctly.

• When the camera is connected to the computer, the time for the auto power off

function is fixed in 30 minutes automatically regardless of the power supply you
use or the settings in the SETUP mode (see page 113).

D2330Z_Body_Eng.qxd.4    00.10.11  5:23  PM    ページ  142