Misc Ikea cardboard Knäppa 사용자 가이드

Please refer to the assembly instructions. The 

2 AAA/LR03 batteries need to be inserted as 

shown before assembling the camera.

 

Hold down the power/shutter button with your 

finger for about 5 seconds. This is on the front 

of the camera under the IKEA logo.

Check that the LED on the back of the camera 

next to the viewfinder. A green light indicates 

the camera is on. 

When the LED is green push the power/shutter 

button firmly (about 2 seconds) until the LED 

starts to blink green.

The LED will blink green for about 8 seconds 

while the picture data is being processed. The 

camera will not take another picture while the 

LED is blinking. Once the LED stops blinking it 

is ready to take the next picture.

Hold down the power/shutter button with your 

finger for about 5 seconds until the green LED 

goes out. The camera will also turn itself off 

after about 30 seconds if it is not used.

Connect the camera to your a computer using 

the built-in USB connector. The IKEA logo 

should face up when plugging the camera into 

a USB port. Once connected the camera will 

appear:

- on a Mac desktop as a folder.

- as a new device in ‘My Computer’ on a 

Windows PC.

The camera does not need to be switched on 

to transfer pictures. 

If the LED on the camera flashes red, the 

camera’s internal memory is full. Before you 

can take more pictures, you need to make 

room for new pictures by deleting older ones. 

To delete pictures make sure the camera is 

turned on. Then use a paperclip to press the 

delete button on the front of the camera for 

about 5 seconds. Note! This will delete all the 

pictures on the camera. Please back-up all the 

pictures on a computer before pressing the 

delete button.

LOW BATTERY                   

The LED on the camera will shine red when 

the camera’s battery power is low. You need to 

replace the batteries as soon as you can.

  

Remove the plastic nuts and bolts at the top 

of the camera, a place them in a safe place. 

Remove the old batteries and then replace 

making sure that the + and – symbols match 

on the new batteries and circuit board. Then 

reassemble.

• To make sure that your pictures are not 

blurred hold the camera still for about 3 

seconds while pushing the power/shutter 

button to make sure your pictures are not 

blurry.

• To help keep the camera steady, rest it on 

something to help keep it stable.

• To improve picture quality avoid low light 

levels.

© Inter IKEA Systems B.V. 2012

Design and Quality

IKEA of Sweden

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s 

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference 

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

—Consult the dealer or an experienced radio/ TV technician for help.

5s

LR03 • AAA