President Industry Development Co. Ltd. 89390 사용자 설명서
MAINTENANCE
© 2012 EyeSpy TM is a registered trademark of EyeSpy Toys Ltd. All rights reserved.
Manufactured for and distributed by Citiwell International Inc.
Conforms to the safety Requirements of CPSIA, ASTM F963 and EN-71(1).
WARNING! . Not suitable for children under 3 years of age due to small parts.
In an effort to continually improve our products, the items inside this package may vary slightly
from the photographs
9-401 Magnetic Drive, Toronto,Canada, M3J 3H9
9-401 Magnetic Drive, Toronto,Canada, M3J 3H9
Customer Care:1866 469 9686
MADE IN CHINA
PRINTED IN CHINA
www.eyespytoys.com
Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly. • If at any time in
the future you should need to dispose of this product please note that Waste Electrical Products should
NOT be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive).
the future you should need to dispose of this product please note that Waste Electrical Products should
NOT be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive).
INSTRUCTION GUIDE
surveillance technology
12+
12+
Do not fly with damaged blades. Please change the blades. To do so gently unscrew the
damaged blade using a small + screwdriver, replace and retighten the screws. Ensure to
use the correct replacement blade.
Additional Replacement blades can be purchased at www.eyespytoys.com or by calling
1866 469 9686.
damaged blade using a small + screwdriver, replace and retighten the screws. Ensure to
use the correct replacement blade.
Additional Replacement blades can be purchased at www.eyespytoys.com or by calling
1866 469 9686.
If at any time the Eagle Spy, or viewer stop working or work in an unexpected
fashion:
1. Check the condition of the batteries, replace the alkaline batteries in the remote
controller and charge the helicopter and viewer.
2. Turn both units off for 15 seconds and then turn them both back on. This will reset the
electronic systems.
For any other problems or concerns, please contact us via the EyeSpy website
www.eyespytoys.com or call our Customer Assistance Line at 1866 469 9686
fashion:
1. Check the condition of the batteries, replace the alkaline batteries in the remote
controller and charge the helicopter and viewer.
2. Turn both units off for 15 seconds and then turn them both back on. This will reset the
electronic systems.
For any other problems or concerns, please contact us via the EyeSpy website
www.eyespytoys.com or call our Customer Assistance Line at 1866 469 9686
www.eyespytoys.com
EaGlE
SPy
TROUBLE-SHOOTING
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.