Comp X Security Products Inc 421860 사용자 설명서
Decelerating Cruise Control
1.
With the cruise speed set, momentarily press the
RESUME/SET switch to SET to reduce the speed by 1
mph (1.6 km/h).
RESUME/SET switch to SET to reduce the speed by 1
mph (1.6 km/h).
2.
Pressing and holding the RESUME/SET switch at SET
will cause the system to continue to reduce speed in
increments of approximately 1 mph (1.6 km/h) until the
switch is released. There is a delay of about 2 seconds
before the speed decreases.
will cause the system to continue to reduce speed in
increments of approximately 1 mph (1.6 km/h) until the
switch is released. There is a delay of about 2 seconds
before the speed decreases.
Deactivating Cruise Control
Rock the CRUISE/SPOT rocker switch forward. The orange
light on the switch will go out to indicate the system is OFF.
light on the switch will go out to indicate the system is OFF.
NOTES
System will NOT work if:
•
An uphill grade is so long and/or steep; the throttle cables
are pulled their full length when the system tries to main-
are pulled their full length when the system tries to main-
tain vehicle speed. This feature prevents stretching the
cables.
cables.
•
Rider operates bike at vehicle speeds below 30 mph (48
km/h) or above 85 mph (137 km/h).
km/h) or above 85 mph (137 km/h).
•
Throttle cables are too tight. See dealer.
•
Brake lamps are on constantly. See dealer.
STOPPING THE ENGINE
1.
Stop the engine by turning OFF the engine stop switch on
right handlebar.
right handlebar.
2.
Turn OFF the ignition/headlamp key switch. If the engine
should be stalled or stopped in any way, turn off the igni-
tion/headlamp key switch at once to prevent battery dis-
charge.
should be stalled or stopped in any way, turn off the igni-
tion/headlamp key switch at once to prevent battery dis-
charge.
SHIFTING GEARS: FLHTCUSE3
Getting Started
The clutch must be fully disengaged before attempting a
gear shift. Failure to fully disengage the clutch can result
in equipment damage. (00182a)
gear shift. Failure to fully disengage the clutch can result
in equipment damage. (00182a)
Operation 131