Shenyang Torch-Bigtide Digital Technology Co. Ltd. 19LCD1928M 사용자 설명서
Last change:
2012-3-1
2012-3-1
User Manual
HL1928M-L/R
Page 10 of
32
In order to ensure safe operation of the equipment, close attention must be paid
to the information contained in this Instruction Manual as well as the warnings in
Section 2 "Safety precautions".
to the information contained in this Instruction Manual as well as the warnings in
Section 2 "Safety precautions".
Caution Information for end customer
None of the settings must be changed on site by the user, otherwise the
guarantee is canceled. This also applies to settings made using the HL1928
M keys. These are therefore locked for certain applications. If settings have to
be changed, please contact the responsible servicing department.
guarantee is canceled. This also applies to settings made using the HL1928
M keys. These are therefore locked for certain applications. If settings have to
be changed, please contact the responsible servicing department.
The display is designed for individual connection to a graphics card with a
power supply of 100 or 240 Volt (TN-S system with PE conductor). If the display
is to be used in a sequence of several displays, or if it is not exactly known
whether the graphics card standard can be output by the display, refer to
Section 5.1 "Connection of the flat panel display".
power supply of 100 or 240 Volt (TN-S system with PE conductor). If the display
is to be used in a sequence of several displays, or if it is not exactly known
whether the graphics card standard can be output by the display, refer to
Section 5.1 "Connection of the flat panel display".
In order to start the unit properly, the following steps should be carried out in the
given sequence.
given sequence.
4.1 Connecting the power and signal cables
Caution
Use a power cable with PE conductor corresponding to the safety requirements
of the respective country of use. Note for North America: Molded power supply
plugs must comply with the requirements for hospitals with respect to CSA Std.
C22.2 No. 21 and UL 498.The power supply and signal connections are located
on the rear of the monochrome flat panel display.
of the respective country of use. Note for North America: Molded power supply
plugs must comply with the requirements for hospitals with respect to CSA Std.
C22.2 No. 21 and UL 498.The power supply and signal connections are located
on the rear of the monochrome flat panel display.
Note
Note that the cables are not positioned when you receive the display (power
cable and BNC cable). The following steps are only necessary if you need to
connect/disconnect the cables of the scope of supply.
cable and BNC cable). The following steps are only necessary if you need to
connect/disconnect the cables of the scope of supply.
4.1.1 Little cover (removing)
Remove the one screws with a M4 Slot screwdriver (one turn suffices). Open
the little cover and remove it
the little cover and remove it