VeryKool USA Inc S5530 사용자 설명서
25
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
‐Reorient or relocate the receiving antenna.
‐Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
that to which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
Body‐worn Operation
This device was tested for typical body‐worn operations. To comply
with RF exposure requirements, a minimum separation distance of
1.0 cm must be maintained between the user’s body and the
handset, including the antenna. Third‐party belt‐clips, holsters, and
similar accessories used by this device should not contain any
metallic components. Body‐worn accessories that do not meet
these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved
antenna.
with RF exposure requirements, a minimum separation distance of
1.0 cm must be maintained between the user’s body and the
handset, including the antenna. Third‐party belt‐clips, holsters, and
similar accessories used by this device should not contain any
metallic components. Body‐worn accessories that do not meet
these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved
antenna.