Luxine Electronical Co. Ltd. 69543 사용자 설명서
Page
3
Item No. OSI-00004 Rev. 3/09
World Wide Induction Range
OPERATING AND
SAFETY INSTRUCTIONS
USING THE FRONT CONTROL PANEL
Single Hob Front Control Panel
Adjusting the power/temp
1. Press the ON/OFF button to turn on the unit. The Power
LED to the right of the POWER/TEMP button will
illuminate. When induction-ready cookware is placed
on the range, the display will remain “steady on” with a
value. This indicates the unit is heating.
illuminate. When induction-ready cookware is placed
on the range, the display will remain “steady on” with a
value. This indicates the unit is heating.
2. Press the POWER/TEMP button to choose a cooking
power level (1 – 100) or an approximate temperature
(100° – 400° F ) or press again for (60° – 210° C). Press
the up or down arrow to increase or decrease the power
level or temperature.
(100° – 400° F ) or press again for (60° – 210° C). Press
the up or down arrow to increase or decrease the power
level or temperature.
Activating the Timer
1. Press the TIMER button. The display will show “1”
with a flashing dot in the lower right corner. The LED
to the right of the POWER/TEMP button will turn off.
to the right of the POWER/TEMP button will turn off.
2. Press the up or down arrow to set the timer from 1 to
180 minutes.
3. When the timer cycle is complete, the unit will turn off.
4. To cancel the timer, press the ON/OFF button. The
timer will turn off. The unit will turn off.
CLEANING
To maintain the appearance and increase the service life,
clean your induction range daily.
clean your induction range daily.
1. Unplug the unit and let it completely cool.
WARNING
BURN HAZARD
The cooking surface gets very hot.
Hot surfaces and hot cookware can burn
skin. Allow the induction range and any
cookware to cool before handling.
The cooking surface gets very hot.
Hot surfaces and hot cookware can burn
skin. Allow the induction range and any
cookware to cool before handling.
WARNING
ELECTRICAL SHOCK HAZARD
Do not spray water or cleaning
products. Liquid could enter the electrical
compartment and cause a short circuit or
electric shock.
Do not spray water or cleaning
products. Liquid could enter the electrical
compartment and cause a short circuit or
electric shock.
2. Wipe the unit exterior with a clean damp cloth.
3. Do not use abrasive materials, scratching cleansers or
souring pad to clean the unit. These can damage the
finish.
finish.
4. Thoroughly wipe off any mild soap or chemical
cleaners. Residue could corrode the surface of the unit.
TROUBLESHOOTING
If
It might be caused by
Course of Action
The unit turned off after five minutes.
There is not a pot/pan on the induction
range or the pot/pan is not induction-ready
range or the pot/pan is not induction-ready
cookware. The induction range turned off.
This is normal.
Make sure the pot/pan is induction ready.
See page 1 of this manual.
See page 1 of this manual.
The unit is on, but not heating.
The cookware may be too small or may not
be induction-ready.
Make sure the pot/pan is induction ready.
See page 1 of this manual.
The digital display lights are flashing.
The overheat-protection feature may have
activated.
activated.
Remove cookware. Let cooking surface
cool.
cool.
The unit suddenly stopped working.
The unit may be too close to an external
heat source or the air intake may be
restricted.
restricted.
Relocate the unit away from any external
heat source. Clear any obstructions to the
air intake.
air intake.
ENGLI
S
H