Practecol LLC EOAREM-002-C 사용자 설명서

Sustainable Solutions

1. Plug the Remote Control Outlet Adapter into an indoor, 

grounded wall outlet.

2. Plug an electrical device into the Remote Control Outlet 

Adapter.

3. Press the remote control to power ON your device as indicated 

by GREEN LED light on the right side of the remote control.

4. When finished using the device plugged into the Remote 

Control Outlet Adapter, turn the device OFF as usual.

5. Then press the switch on the remote control to cut OFF 

standby power to the device.

6. When you want to use the device again, FIRST use the remote 

control to activate power into Remote Control Outlet Adapter.

7. Then turn ON the device you wish to use.

8. REPEAT steps 4 & 5 as necessary.

Outlet Adapter

www.

practecol.com

sustain 

save

simply

™

& 

PMS  376c

EOAREM-002

125V~60HZ-10A

TUNGSTON LOAD..240W

This device complies with Part 15 of the FCC Rules. Operation is subject to 

the following two conditions: (1) this device may not cause   harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible 

for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interfer-

ence in a residential installation. 

This equipment generates uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one or 

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to  

   which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.