Essence Security International ltd. ES6500EGE 사용자 설명서
Installation
8
EverGuard Express
backup power during temporary loss of power source.
Caution: There is a danger of explosion if an incorrect battery type is
inserted. Dispose of the used battery properly. Consult your local
regulations or waste disposal provider.
inserted. Dispose of the used battery properly. Consult your local
regulations or waste disposal provider.
To insert the SIM card and battery:
1. Holding the EverGuard Express panel, using a screwdriver (or other blunt
instrument) push in on the latch and pull the back component away from the
front panel. The inside is exposed.
front panel. The inside is exposed.
2. Turn over the front component so that its rear side is facing you.
Figure 1: EverGuard Express panel Bottom View
3. To insert the SIM card, align the SIM card so that the cut-off corner in the
lower-right corner and place it in the lower-right corner of the compartment.
WARNING!
Trying to insert a SIM card in the wrong direction can damage
the SIM card. Be sure to follow the above figure to assure the correct
alignment.
alignment.
4. Slide the SIM card toward the center of the panel. It snaps into place.
5. To inset the battery, note the contacts on the battery.
6. Hold the battery side with the writing to the top. Align the battery so that the
contacts are pointed to the battery contacts in the battery compartment.
7. Insert the battery at an angle toward the contacts, so that the battery
contacts comment to the corresponding one on the EverGuard Express unit
and push the battery into the compartment.
and push the battery into the compartment.
8. To reattach the EverGuard Express back component, align its catches with
those of the front panel component.
9. Push the two components together. The clip snaps into place.
To select a mounting location:
The EverGuard Express should be mounted on the wall using the wall mount