Essence Security International ltd. ES800TR5 사용자 설명서
Installation of the We.R™ System
136
We.R
™
System User Guide
The Tag Reader should be mounted (with the release tab pointing down) on a flat
vertical surface.
Attach the Tag Reader to a surface that is clean, dry, flat and smooth.
The Tag Reader must be mounted within 700m (2300ft) (open air nominal) of the CCU.
3.10.2.2.
Installing with Screws
1.
Release the Tag Reader mounting base by lifting the tab and sliding the base in the tab’s
direction as demonstrated in Figure 101 above.
2.
Place and hold the base on the desired mounting location and mark the drilling locations.
3.
Drill the holes; insert three (3) dowels if needed, place the base over them and screw in the
three (3) screws.
4.
Slide the Tag Reader back onto its mounting base.
3.10.2.3.
Installing with Pre-attached Double-side Tape
1. Release the Tag Reader mounting base by lifting the tab and sliding the base in the tab’s
direction as demonstrated in Figure 101 above.
2. Clean the surface where the Tag Reader should be installed.
3.
Peel the tapes’ protective covers.
4.
Attach the mounting base to its designated location while applying slight pressure.
5.
Slide the Tag Reader into the mounting base.
3.10.2.4.
Dismounting the Tag Reader
For dismounting the Tag Reader from its designated installation site:
1.
Press over the tab.
2.
Slide the Tag Reader body upwards as demonstrated in Figure 103 below.