Vihaan Networks Ltd. RBTS850R2 사용자 설명서
B S S
C
O N F I G U R A T I O N A N D
U
S E R
G
U I D E
© VNL
®
2010-2011, All rights reserved
Commercial in Confidence
Page 21
• Disconnect: Used to disconnect a ME from a network.
• Shut Down Active: Used to shutdown a ME, which is in
• Shut Down Active: Used to shutdown a ME, which is in
active state. The standby card becomes active. This puts
the card in hot swap state (meant for maintenance
purpose) and you can jack-out the card. This is also
called as graceful shutdown of the processes.
• Shut Down Standby: Used to shutdown a ME, which is in
standby mode. This puts the card in hot swap state
(meant for maintenance purpose) and you can jack-out
the card. This is also called as graceful shutdown of the
processes.
• Block: Used to block a ME from accessing or using a
network.
2.3 BSS Configuration Workflow
The figure below depicts the workflow for configuring the
BSS node:
After assigning the BSS node to OMC, you should configure
trunkport so that BSC, BTS, and MSC can communicate
with each other.
You can configure stack, radio, and software after
configuring BSC.
In addition, you should follow the procedure given in the
following sections of this document to successfully configure
and manage the BSS node.