Vihaan Networks Ltd. RBTS850R2 사용자 설명서

© VNL

®

 2010-2011, All rights reserved 

Commercial in Confidence                      

     Page 31 

 

4.  Click an active trunkport. 

5. Click Deactivate TrunkPort in the Options panel. 

6. Click Modify to deactivate the trunkport. 

The Confirmation message box appears. 

7. Click Ok. 

MLPPP is a communication protocol that enables a 

computer to use two point-to-point ports as a single port of 

greater bandwidth.  Point-to-point protocol (PPP) is a full-

duplex protocol that uses a serial interface for 

communication between systems. PPP offers error 

correction and can handle synchronous as well as 

asynchronous data. For example, if you combine two 

modems and connect to the Internet then the data transfer 

rate increases. Similarly, MLPPP increases the data transfer 

rate. 

The data transfer rates of the two links should be similar. 

Otherwise, the slower link decreases the overall throughput. 

After installing MLPPP drivers, you can configure MLPPP in 

OMC. For more details on the installation procedure, please 

refer to “OMC Installation Guide- Appendix A”. You 

configure MLPPP for each trunkport by assigning timeslots. 

LNote

: You should always configure MLPPP from OMC 

only. Failure to do so may introduce inconsistencies. 

Perform the below steps to configure MLPPP: 

1.  Open the BSS node in the modify mode.  

2. Right-click IPConfig and click Add MLPPP.