AUREL Spa 058402 사용자 설명서

                                                                                                                                        Owner’s Manual                   

 

Inside the front half shell of the transmitter plastic container, there is a label  which contains the device’s 

identification data (product’s name, manufacturer, feed voltage and power consumption).  
 
 

 

 

       

 

 

Carrier’s frequency  

 

433.92 

± 0.15 

 MHz 

Radiated power (E.R.P.) 

 

 

0 

dBm 

Modulation 

 

OOK (On Off Keying) 

 

 

Power consumption 

 

7 

15 

mA 

Operating temperature 

-10 

 

+55 

°C 

Dimensions 

75 x 43.5 x 18.5 mm 

 

 
TX3750-1C-SAW 434, TX3750-2C-SAW 434 and TX3750-4C-SAW 434 transmitters comply with  

European Regulations ETS 300-220, ETS 300-683 and EN 60950.  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

this device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

 

1. 

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to 
operate the equipment.

 

2. 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 

FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television  reception, which can be determined by turning the equipment off and on,  the user is encouraged to try to 
correct the interference by one or more of the following measures:

 

 

-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
-  Consult the dealer or an experienced radio/TV technician for help.

 

 
The technical reports have been issued by the laboratory of the Company :  

PRIMA RICERCA & SVILUPPO – via Campagna, 58 – 22020 Gaggino Faloppio (CO) - Italy.

 

AUREL shall not be deemed liable if product and related information are changed without notice. The Buyer shall be the sole responsible of the device use. 

 
AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY                                                            Rev. B,  July 17th  2003 
Tel.: +390546941124 – Fax: +390546941660                                                                                                                Pag  2 of 2 

http://www.aurel.it

  -  email: 

aurel@aurel.it