INNOSYS Co. LTD. ER300A 사용자 설명서
ECHO Rev A INSTALLATION
MANUAL
I
8
INNOSYS
seconds after each temporary disarm or after an activation of the optional trunk release feature. In passive
mode the system can be MANUALLY ARMED anytime during the thirty second automatic arming cycle.
mode the system can be MANUALLY ARMED anytime during the thirty second automatic arming cycle.
Active arming mode means that the system will not arm until you manually turn it on by pressing the arming
button on your radio frequency transmitter. Sometimes referred to as Manual Arming.
button on your radio frequency transmitter. Sometimes referred to as Manual Arming.
1. Switch #3 ON = Passive.
2. Switch #3 OFF = Active.
Note: All original factory and/or programmed settings are retained in permanent memory
2. Switch #3 OFF = Active.
Note: All original factory and/or programmed settings are retained in permanent memory
5.3 Drive Lock Mode (Factory Default Setting: Drive Lock Mode Off)
Drive Lock Mode means that all doors will lock automatically two (2) seconds after the ignition key is turned on
and will unlock automatically when the ignition key is turned off. This assumes that the keyless entry option
has been installed by your Dealer. Sometimes referred to as Ignition Lock.
and will unlock automatically when the ignition key is turned off. This assumes that the keyless entry option
has been installed by your Dealer. Sometimes referred to as Ignition Lock.
1. Switch #4 ON = Drive Lock Mode On.
2. Switch #4 OFF = . Drive Lock Mode Off
2. Switch #4 OFF = . Drive Lock Mode Off
5.4 Shock Sensor Adjustment
Shock sensor can be adjusted from Volume in RF Antenna.
To adjust sensitivity:
To adjust sensitivity:
1. Turn
clockwise
To increase sensitivity
2. Turn
counterclockwise
To decrease sensitivity
Adjustment
MIN
MIN
Å 10 – 8 – 6 – 4 – 2 – 0 -> MAX
SECTION 6: DEALER PROGRAMMABLE FEATURES
To program DEALER FUNCTIONS: Method 1
1. Open the door.
2. With your vehicle key in key cylinder, turn it to ignition on position (Driving Position).
3. Press and hold antenna switch and Press and release the Transmitter button
4. The system will exit programming mode, if there’s no transmitter activity for 10 seconds, if ignition is
1. Open the door.
2. With your vehicle key in key cylinder, turn it to ignition on position (Driving Position).
3. Press and hold antenna switch and Press and release the Transmitter button
4. The system will exit programming mode, if there’s no transmitter activity for 10 seconds, if ignition is
turned off, or if door is closed
FUNCTION
Remote
Button
Set
Reset
1
Start Disable
1
Disable
Enable *
2
Shock Sensor Disable
2
Disable
Enable*
3
Passive Lock Mode
3
OFF
ON*
4
Drive Lock Only Mode
4
ON
OFF*
*Note: Factory default settings are highlighted.
6.1 Remote Start Enable/Disable (Factory default setting: Remote start Enable)
Remote Start Function can be enabled and disabled from This Function.
6.2 Shock Sensor Disable/Enable (Factory Default Setting: Shock Sensor Enable)
The Shock Sensor Disable means that the on-board body shock sensor can be eliminated through Function
switch at any time it is desired or necessary.
switch at any time it is desired or necessary.
NOTE: The keyless entry option must be installed by your Dealer for the functions described above
under keyless entry mode to be operational.
under keyless entry mode to be operational.