Dust Networks Inc. M1030 사용자 설명서

 Regulatory and Standards Compliance

M1030-2 M

OTE

 D

ATASHEET

25

The M1030-2 can be hand soldered with a soldering iron at 230 °C. The soldering iron should be in contact with the pin for 10 
seconds or less. The M1030-2 is also suitable for eutectic PbSn reflow.

The M1030-2 mote complies with Part 15.247 modular (Intentional Radiator) of the FCC rules and regulations. In order to 
fulfill FCC certification requirements, products incorporating the M1030-2 mote must comply with the following:

1. An external label must be provided on the outside of the final product enclosure specifying the FCC identifier 

 

(SJC-M1030), as described in 9.1.3 below.

2. The antenna must be electrically identical to the FCC-approved antenna specifications for the M1030-2 as described in 

 

9.1.2 with the exception that the gain may be lower than specified in Table 44.

3. The device integrating the M1030-2 mote may not cause harmful interference, and must accept any interference received, 

including interference that may cause undesired operation.

4. An unintentional radiator scan must be performed on the device integrating the M1030-2 mote, per FCC rules and 

regulations, CFR Title 47, Part 15, Subpart B. See FCC rules for specifics on requirements for declaration of conformity.