GRAUPNER CO. LTD. 16007700 사용자 설명서
15 / 36
S1036.77_jh_V1_de
PC COM Port connection
Through this socket it is also possible to connect the transmitter
to a PC. The software that the computer needs as well as the
appropriate USB driver can be found on the download page on
www.graupner.de
for the respective product.
Mass storage memory
If you select this option, then you can accede from your PC
directly to the SD card (if insert).
2- Data socket
The data socket is suitable for connection of an optional smart
The data socket is suitable for connection of an optional smart
box or an external optional Bluetooth module.
DSC socket
Connection socket for flight simulator or T/P systems
The standard two-pin DSC socket on the transmitter functions
The standard two-pin DSC socket on the transmitter functions
as a TRAINER or PUPIL socket as well as an interface for flight
simulators or other external RF modules.
To ensure a correct DSC connection, observe the following:
To ensure a correct DSC connection, observe the following:
Attention
When your transmitter is directly connected to a desktop computer
by a connecting cable (DSC cable) and/or a computer interface is
connected to your simulator, the transmitter may be destroyed
by electrostatic discharge. This type of connection should therefore
only be used if you protect yourself from electrostatic discharge
while operating the simulator by wearing a commercially available
grounding armband. Graupner therefore strongly recommends only
using wireless simulators.
Perform any necessary adaptations in the menu.
When using the transmitter with a flight simulator or during the
When using the transmitter with a flight simulator or during the
teacher-pupil operation, leave the transmitter
always OFF. Only
in this position even after connecting the DSC cable the RF
module of the transmitter remains inactive. Connect now the
DSC cable and switch the transmitter on.
The status LED is constantly red and in the display will appear
The status LED is constantly red and in the display will appear
DSC.
In the upper display appears the transmitter logo.
The transmitter is now ready for use.
In the upper display appears the transmitter logo.
The transmitter is now ready for use.
Note
If the transmitter is used as teacher transmitter it has to be switched
on before connecting the proper cable.
Connect the other end of the connecting cable to the device
while observing the relevant operating instructions.
PUPIL
#11
0:01h
S
F
«normal »
DSC
0:00.0
0:00.0
4.1V
0.0V
HoTT