GRAUPNER CO. LTD. 16007812 사용자 설명서
25 / 28
S1002.PRO_jh_V1
Firmware update
The programs and files which are also required for updating the
transmitter combined into one software package can be down-
loaded from
www.graupner.de
.
Download this software package from the Internet, and unpack it on
your computer. All other information can be found in internet in the
same page where the software package is available.
Firmware updates of the transmitter can be performed through the
micro USB port on the back side.
Firmware updates of the transmitter can be performed through the
micro USB port on the back side.
Note
Please note that compatible firmware is required for reliable
communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.
communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.
The current firmware version can be found on the Internet at
www.graupner.de.
www.graupner.de.
Only operate your transmitter using the current software ver-
sion. these information can also be found at: www.graupner.de
=> Service & Support => Update and revision history for
GRAUPNER HoTT components.
sion. these information can also be found at: www.graupner.de
=> Service & Support => Update and revision history for
GRAUPNER HoTT components.
Before each update, check the transmitter battery charge or
charge it as a precaution, and save all model memories with the
gr_studio program so that they can be restored if necessary.
charge it as a precaution, and save all model memories with the
gr_studio program so that they can be restored if necessary.
Do not disconnect the link to the computer during an update!
Make sure that the link between the transmitter and computer
is operational.
Make sure that the link between the transmitter and computer
is operational.
After each update, check to make sure that the models function
correctly.
correctly.
Transmitter software update
Connect your switched off transmitter with your PC, by using the
included USB cable, which is supplied with the package content, plug
USB cable directly to the micro USB port of the transmitter and the
other end to a free port in your computer.
Restoring the transmitter software
If a firmware update for the transmitter is unsuccessful or the trans-
mitter program freezes and the transmitter cannot be turned off
using the "POWER" switch, then remove the transmitter's battery
after setting the switch to "POWER = OFF" position, or pull the plug
from the transmitter battery. While making sure that the POWER
switch is in the "OFF" position, wait a few seconds and then turn on
the battery.