BMI Technologies Inc. RFVI 사용자 설명서

G FORCE PLUS RF Instruction Manual 

 

 

Apr/08

Doc #RF1 Rev.9 

“LOGIN DECLINED CARD EXPIRED” 

Expired Operator or Lockout Card, or Operator Card 
with an expired Recertification Date 

“LOGIN DELINED NOT AUTHORIZED”  Operator Card with wrong Authorization Group or 

Single Vehicle assignments, or unassigned Operator 
Card 

 
 

 
1.  Press {Yes} on the Vehicle Interface when it displays “VEH INSPECTION YES TO START” The 

Vehicle Interface will display the first item on the list as defined in the Authorization Group for the 
Vehicle.  The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if {No} or 
{Cancel} is pressed.  

2.  Conduct the necessary test (i.e. visual inspection or operation of controls) to determine if the item should 

pass or fail. 

3.  Press {Pass} on the Vehicle Interface to indicate the item has passed.  The Vehicle Interface will display 

the next item on the list as defined in the Authorization Group for the Vehicle.  Repeat steps 2 and 3 until 
the Vehicle Interface displays “VEH INSPECTION COMPLETE, PASSED”, OR 

4.  Press {Fail} on the Vehicle Interface to indicate the item has failed.  The Vehicle Interface will display 

“VEH INSPECTION FAILURE? YES/NO” 

5.  Press {Yes} to confirm the failure of the Vehicle Inspection.  The Vehicle Interface will display “MAINT 

LOCK OUT YYYY/MM/DD HH:MM” to indicate it is in Maintenance Lockout, OR 

6.  Press {No} to cancel the failure of the Vehicle Inspection.  The Vehicle Interface will display the item in 

question again and wait for a {Pass} or {Fail} key press.   

7.  The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if {Cancel} is pressed 

in response to any Vehicle Inspection item. 

8.  The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if there is no keypad 

response from the Operator within the period of time determined by the Vehicle Inspection Inactivity 
Timer under the System Settings. 

 

 

 

 
 

 
1.  A Vehicle enters Operating state after a Passed Vehicle Inspection, or after a successful Operator Login if 

no Vehicle Inspection was required.  The Vehicle Interface will display “OPERATING MODE”.  This 
message will alternate with “BATTERY (STATE OF CHARGE)” if the Authorization Group of the 
Vehicle requires Battery Monitoring. 

 

2.  Key-off the Vehicle to end the Login session for the current Operator.