BMI Technologies Inc. RFVI 사용자 설명서

G FORCE PLUS RF Instruction Manual 

 

 

Apr/08

Doc #RF1 Rev.9 

 
Changes or modifications not expressly approved by the party responsible for compliance could void the 
user’s authority to operate the G FORCE PLUS Vehicle Interface, G FORCE PLUS Data Logger, G 
FORCE PLUS RF Vehicle Monitor, G FORCE PLUS RF Host Transceiver, and G FORCE PLUS RF 
Zone Transceiver. 
 
 

 
The following warning applies to the G FORCE PLUS Vehicle Interface, G FORCE PLUS RF Vehicle 
Monitor, G FORCE PLUS RF Host Transceiver, and G FORCE PLUS RF Zone Transceiver: 
 
WARNING:  This device meets the FCC/IC requirements for RF exposure when the antenna used for 
this transmitter has a separation distance of at least 20 cm from all persons and must not be co-located or 
operating in conjunction with any other antenna or transmitter which is closer than 20 cm. 
 
The installer of this radio equipment must ensure that the antenna is located or pointed such that it does 
not emit RF field in excess of Health Canada limits for the general population as indicated by Safety Code 
6.  
 
 

 
The Data Logger is a hand-held device used to transfer data between the Fleet Manager Software and a 
Vehicle Monitor.  The power source is a single 9-volt battery, stored in the battery compartment at the back of 
the unit.  A slot screwdriver opens the compartment for battery replacement. 
 
1.  Press {Enter} on the Data Logger to start its self-test.  The Data Logger will display: 

a.  “Selftesting…” 
b.  “SelfTest Passed Firmware 1V6” 
c.  “Action?(1-9)” 

2.  Press each number one at a time from {1} to {9} and watch the Data Logger display change for each 

selection: 

1   

Events to PC 

 

Download Vehicle data to Software  

2   

Get Vehicle ID   

Get Vehicle ID from Software 

3   

Get Veh Settings 

Get Vehicle settings from Software 

4   

Events from Veh 

Collect Vehicle data (backup data collection method) 

5   

Prog Veh ID 

 

Program Vehicle ID to Vehicle Monitor 

6   

Prog Veh Settngs 

Program Vehicle settings to Vehicle Monitor 

7   

Date / Time 

 

Transfer Date / Time from Software to Data Logger to Vehicle 

8   

Hot Card List   

Transfer Hot Card List from Software to Data Logger to Vehicle 

9   

Clear Data 

 

Clear Data Logger data (ID’s, Settings, and Events) 

3.  Press {7}.  The Data Logger will display “Action?(1-9) Date / Time” 

4.  Press {Cancel}.  The Data Logger will revert to “Action?(1-9)” 

5.  Press {4}.  The Data Logger will display “Action?(1-9) Events from Veh” 

6.  Press {Enter}.  The DATA LOGGER will display “Ready for Events” 

7.  Do not press the keypad for one minute.  The Data Logger will automatically shut down.