EnOcean GmbH PTM210C 사용자 설명서

USER MANUAL V0.9 

EnOcean GmbH 
Kolpingring 18a 
82041 Oberhaching 
Germany 

Phone +49.89.67 34 689-0 
Fax +49.89.67 

34 

689-50 

info@enocean.com 
www.enocean.com 

Subject to modifications 
PTM 210 / PTM 210C User Manual V0.9 
July 7, 2010 9:36 AM 
Page 11/18 

 

PTM 210 / PTM 210C 

 
Processor 

Converts the contact nipples’ status and pushed/released data from the power generator 

into a reliable and energy-efficient serial telegram structure. 

 
HF transmitter 

Sends the data in the form of a series of short radio signals. 

 

 
With 4 contact nipples, the PTM 210 offers 2 channels with 4 action states each (up-

per/lower nipple is pressed/released when activating the energy bow). The nipples’ desig-

nation is as follows: 

 

 

 

 

Radio signals of the PTM 210 device are event-controlled (energy bow is pressed/released) 

with contact nipple code (channel/state) and unique device identification (fixed 32-bit ID). 

When operating more than one nipple at the same time, note that PTM 210 sends multiple-

button code combinations: 
 

„ 

N-message: One or two contact nipples have been pressed when activating the energy 

generator Æ Message with nipple code and pressed/released event status of the energy 

bow is sent. 

„ 

U-message: No contact nipple was pressed when activating the energy generator, or 3 

or 4 nipples have been pressed Æ Message with pressed/released event status of the 

energy bow is sent and the information if either none or more than two nipples have 

been pressed. Note that it can’t be differentiated if 3 or if 4 nipples have been pressed.  

 

 

Due to the mechanical hysteresis of the energy bow, in most rocker switch device 

implementations, pressing the rocker sends an N-message and releasing the 

rocker sends a U-message! 

O

I

B

A

CHANNEL

STATE

O

I

B

A

CHANNEL

STATE