EnOcean GmbH PTM330U 사용자 설명서
USER MANUAL
V1.2
© 2010 EnOcean | www.enocean.com
PTM 33x / PTM 33xC / PTM 330U User Manual V1.2 | Page 12/27
PTM 33X / PTM 33XC / PTM 330U
U-message:
DATA_BYTE3:
7 0
BUTTONS
PR
Reserved
BUTTONS
(3 bit)
Number of simultaneously pressed buttons, as following:
0 = 0 Button
1 = not possible
2 = not possible
3 = 3 or 4 buttons
4 = not possible
5 = not possible
6 = not possible
7 = not possible
2 = not possible
3 = 3 or 4 buttons
4 = not possible
5 = not possible
6 = not possible
7 = not possible
PO
(1 bit)
Polarity, see table below
Reserved
(4 bit)
STATUS:
7 0
Reserved T21 NU
RP_COUNTER
Reserved
(2 bit)
For future use
T21
(1 bit)
1
NU
(1 bit)
NU=0 U-message.
RP_COUNTER
(4 bit)
Repeater level: 0 is original message (not repeated)
The polarity PO is defined as follows:
3.7.2 User defined operation
Via the configuration interface it is possible to define different content of DATA_BYTE3 and
Via the configuration interface it is possible to define different content of DATA_BYTE3 and
define if a N-message or U-message shall be sent. This allows for example to transmit
other RORG=F6 telegrams, e.g. “Mechanical handle”, as described in the EnOcean Equip-
ment Profiles defined by EnOcean Alliance.
For details please refer to the EnOcean Equipment Profiles 2.1 specification.
http://www.enocean-alliance.org/fileadmin/redaktion/enocean_alliance/pdf/EnOcean_Equipment_Profiles_EEP2.1.pdf
3.8 Transmit timing
The setup of the transmission timing allows avoiding possible collisions with data packages
of other EnOcean transmitters as well as disturbances from the environment. With each
transmission cycle, 3 identical subtelegrams are transmitted within 40 ms. The transmis-
sion of a subtelegram lasts approximately 0.7 ms. The delay between the three transmis-
sion bursts is affected at random.
AC1
AC2
PO
-
+
1
+
-
0