TP-Link Technologies Co. Ltd. C20I 사용자 설명서

 

- 24 - 

This page displays the WAN IP parameters assigned dynamically by your ISP, including IP 

address, Subnet Mask, Default Gateway, etc. Click the Renew button to renew the IP 

parameters from your ISP. Click the Release button to release the IP parameters. 

If you want to do some advanced configurations, please click the Advanced button. 

¾

  MTU (Bytes) - The normal MTU (Maximum Transmission Unit) value for most Ethernet 

networks is 1500 Bytes. It is not recommended that you change the default MTU size unless 

required by your ISP.   

¾

  Enable Fullcone NAT - It is a type of NAT, if not enabled, the default NAT will act. 

¾

  Enable IGMP Proxy  - IGMP (Internet Group Management Protocol) is used to manage 

multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration for 

client devices, such as the modem router. The default value is enabled, and if you are not 

sure, please contact your ISP or just leave it. 

¾

  Get IP with Unicast - A few ISPs' DHCP servers do not support the broadcast applications. If 

you cannot get the IP Address normally, you can choose this option. (It is rarely required.) 

¾

  Set DNS server manually - If your ISP gives you one or two DNS addresses, select Set 

DNS server manually and enter the primary and secondary addresses into the correct fields. 

Otherwise, the DNS servers will be assigned automatically from your ISP.   

)

If you find error when you go to a website after entering the DNS addresses, it is likely that 

your DNS servers are set up improperly. You should contact your ISP to get DNS server 

addresses.  

¾

  Host Name - This option specifies the Host Name of the router. 

Click the Save button to save your settings. 

2.  If your ISP provides a static or fixed IP Address, Subnet Mask, Gateway and DNS setting, 

select Static IP. The Static IP settings page will appear, shown in Figure 4-4.