TP-Link Technologies Co. Ltd. WR1043NDV2 사용자 설명서

 

)

After a device is successfully added to the network by WPS function, the WPS LED will keep on 
for about 5 minutes and then turn off.

 

 

Figure 1-2    Rear Panel sketch 

The following parts are located on the rear panel (View from left to right). 

¾

  Wireless On/Off: The switch for the wireless function. 

¾

  Ethernet (1, 2, 3, 4): These ports (1, 2, 3, 4) connect the router to the local PC(s). 

¾

  Internet: This port is where you will connect the DSL/cable Modem, or Ethernet. 

¾

  USB: The USB port connects to a USB storage device or a USB printer. 

¾

  On/Off: The switch for the power. 

¾

  Power:  The Power socket is where you will connect the power adapter. Please use the 

power adapter provided with this TL-WR1043ND 300Mbps Wireless N Gigabit Router.   

¾

 

WPS/Reset:   

Pressing this button for less than 5 seconds enables the WPS function. If your client devices, 

such as wireless adapters, that support Wi-Fi Protected Setup, then you can press this 

button to quickly establish a connection between the router and client devices and 

automatically configure wireless security for your wireless network.   

Pressing this button for more than 5 seconds enables the Reset function. With the router 

powered on, press and hold the WPS/Reset button (approximately 8 seconds) until the SYS 

-5-