Orange Electronic CO. LTD P420 사용자 설명서
Manual for Tire Pressure Monitoring Systems, TPMS
20/21
Troubleshooting Guide
1. The receiver shows no display after its power is turned on.
1.The power cord connector is not in full contact with the receiver
Solution: Remove the power cord and plug it into the outlet again until it is seated
completely
completely
.
2.The power cord has failed
Solution
：
Ask your distributor to have your power cord replaced and send the
failed one back to its manufacturer for repair.
3.
The battery is run out of power.
Solution：If the battery voltage is always lower than 9V every time you start the
engine, it is recommended that the car should be brought to the service center for
inspection.
4. The digits shown on the display panel become incomplete, or the light indicators
become abnormal.
Solution：Ask your distributor to have your receiver replaced, reconfigure its ID
using the Tire Switching Mode (Mode IV), and send the failed receiver back to
its manufacturer for repair.
using the Tire Switching Mode (Mode IV), and send the failed receiver back to
its manufacturer for repair.
2. The Setup button or the Conversion button has no response.
1.
The inner circuits of the receiver has failed
Solution
：Ask your distributor to have your receiver replaced, reconfigure its ID using the Tire
Switching Mode (Mode IV), and send the failed receiver back to its manufacturer for repair.
3. The receiver cannot receive signal from one or some certain tires (but not all of
them) after its power is turned on the numeric values representing the locations
of those tires displayed on the screen become “E2”.
of those tires displayed on the screen become “E2”.
1. There is interference from other electronic device in the vehicle.
Solution
：Remove other electronic device in the vehicle to determine if there is other
interference.
2.
The IDs of those tires are not designed correctly
Solution
：
Ask your installment vendor to reconfigure the IDs of those tires by using
the Single Sensor Replacement Mode(Mode V)
3. The emitters of those tires have failed.
Solution
：Ask your distributor to have those emitters replaced, reconfigure the IDs of those
tires by using the Single Sensor Replacement Mode (Mode V), and then send the failed
emitters back to their manufacturer for repair.
emitters back to their manufacturer for repair.