Light-O-Rama Inc. RF02 사용자 설명서
LOR-RF-V4
Page 13
transceiver where water can splash upward or
be forced into the case from below. (I.e. avoid
mounting it where an irrigation system may
force water up into the case.)
be forced into the case from below. (I.e. avoid
mounting it where an irrigation system may
force water up into the case.)
4. Don’t use data cables with boots. The boot
results in too tight a fit against the transceiver
case and puts too much stress on the RJ45
jack when the bottom cover is put on.
case and puts too much stress on the RJ45
jack when the bottom cover is put on.
5. After connecting the data cable, route the
wire though the notch in the bottom panel.
The notch should be placed on the opposite
side of the case from the RJ45 jack to
minimize strain on the RJ45 connector.
The notch should be placed on the opposite
side of the case from the RJ45 jack to
minimize strain on the RJ45 connector.
6. Always put the bottom on the case after
connecting the communications cable.
7. If you are using the device to connect from an
indoor show director (PC or MP3 Director) to
outdoor controllers be aware that the walls
the signal must pass through will affect the
range. If the house is covered in aluminum,
you may have to place the transmitter in a
window.
outdoor controllers be aware that the walls
the signal must pass through will affect the
range. If the house is covered in aluminum,
you may have to place the transmitter in a
window.
8. NEVER remove the antenna. It is sealed to
the case with silicone and removing it will
break this seal possibly allowing water to
enter and destroy the transceiver.
break this seal possibly allowing water to
enter and destroy the transceiver.
LOR-RF-V4
Page 14
Circuit Board
Easy Light Linker Open Bottom
The above picture shows the Easy Light Linker with
the bottom cover removed. The RJ45 connectors for
power and communication are on the lower left. The
CPU is above the RJ45 connectors. The transceiver
module is the postage stamp sized surface mount
board on the upper right.
The transceiver contains no user serviceable parts.