S and C Electric INTELLICOM 사용자 설명서

 

                                                      S&C Instruction Sheet 1069-500      13

Appendix B 

Regulatory

FCC Class A Notice

This equipment has been tested and found to comply with the limits for a Class 

A digital device. These limits are designed to provide reasonable protection 

against harmful interference in an office installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio com-

munications. However, there is no guarantee that interference will not occur in 

a particular installation. If this equipment does cause harmful interference to ra-

dio or television reception, which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures: 
•  Reorient or relocate the receiving antenna. 
•  Increase the separation between the equipment and receiver. 
•  Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected. 

•  Consult the dealer or an experienced radio/television technician for help. 

FCC Part 15 Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 
•  This device may not cause harmful interference. 
•  This device must accept any interference received, including interference 

that may cause undesired operation. 

FCC Part 90 & Public Safety Statement

This equipment has been tested pursuant to FCC Part 90, DSRC-C mask certi-

fication, and is approved for use in the US on Public Safety bands by licensed 

Public Safety agencies. 
Pursuant to Part 90.1215, use of antennas with gain greater than 9 dBi and up 

to 19 dBi in the 4.940 - 4.990 GHz Public Safety band is permissible without 

reduction of TX output power. The antenna shall have a directional gain pat-

tern in order to meet the requirement of point to point and point to multi-point 

operation.

Modification & Antenna Installation Statement

 Any modifications made to this device that are not approved by S and C, Inc. 

may void the authority granted to the user by the FCC to operate this equip-

ment. Antenna(s) for this unit must be installed by a qualified professional. Op-

eration of the unit with non-approved antennas is a violation of U.S. FCC Rules, 

Part 15.203(c), Code of Federal Regulations, Title 47. 

Appendix B: Regulatory