BandRich Inc. P530A 사용자 설명서

8

 

 

 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may 
cause undesired operation. 
 
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules.    These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful 
interference to radio communications.    However, there is no guarantee that 
interference will not occur in a particular installation.    If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one of the following measures: 
 
- 

Reorient or relocate the receiving antenna. 

- 

Increase the separation between the equipment and receiver. 

- 

Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 
- 

Consult the dealer or an experienced radio/TV technician for help. 

 
FCC Caution: Any changes or modifications not expressly approved by the party 
responsible for compliance could void the user's authority to operate this equipment. 
 
This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter. 
 

Radiation Exposure Statement: 

The product comply with the FCC portable RF exposure limit set forth for an 
uncontrolled environment and are safe for intended operation as described in this 
manual. The further RF exposure reduction can be achieved if the product can be kept 
as far as possible from the user body or set the device to lower output power if such 
function is available.