PAX Technology Limited S500RF 사용자 설명서

（S500） 

POWER port connects to the external power adapter. 

LINE port connects to telephone line. 

PINPAD port connects to PINPAD. 

RS232 port connects to serial port. 

LAN port connects to the network cable (optional). 

PHONE port connects to telephone (optional). 

1）Power ON/OFF 

Power on：Press the ON/OFF button

  two seconds until LCD backlight light, the terminal turns on 

successfully. 

Power off：Press the ON/OFF button

 two seconds until LCD no

 

display, the terminal turns off 

successfully. 

2）Magnetic Stripe Card 

Put magnetic stripe side of magnetic card towards device interior, swipe the card with a steady speed 

during through magnetic reader slot. (Support bi-directional swiping) 

3）IC Card 

Put IC card chip side upward, push-in IC card slot and to bottom. 

4）Tap contactless card (optional).

 

Put the contactless card into the sensing area above the LCD 

5）Shred paper operating Instructions 

Make paper 45 degrees angle right to paper knife and shred paper. 

1）Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment. 

2）Forbid non-professional to repair the terminal. 

3）Before insert the card, please check internal and around of IC card slot . when you found some suspicious 

objects , must report to related administrator. 

It is highly recommended to enter password as following ways: 

1）Set up peep shields. Enter password with shield by the structures of cashier desk; 

2）Place the POS terminal at an appropriate angle and make sure it is difficult to peer the password. For 

example, the POS was installed above the movable bracket. 

3）In enter password perspective, avoid surrounding video surveillance; 

4）Paste text instructions to remind the customers to shelter with body or palm when enter password. 

5）Merchants can also choose other ways to protect the customer input password. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the