ADC Telecommunications Inc. AUAC85 사용자 설명서

다운로드
페이지 108
 
iii
United States Federal Communications Commission Required User Information
Located on the equipment is a label that contains, among other information, the FCC registration number. If 
requested, this information must be provided to the telephone company.
The UltraWAVE BTS Series AUAC series complies with Part 22 of the FCC Rules.
The 1900 MHz WAVEXpress Series M50 complies with Part 24 of the FCC Rules.
This equipment cannot be used on the telephone company-provided coin service. Connection to Party Line 
Service is subject to State Tariffs.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance 
that temporary discontinuance of service may be required. If advance notice isn’t practical, the telephone 
company will notify the customer as soon as possible. Also, you will be advised of your right to file a 
complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, of procedures that could 
affect the operation of the equipment. If this happens, the telephone company will provide advance notice in 
order for you to make the necessary modifications in order to maintain uninterrupted service. 
If trouble is experienced with this equipment, please contact:
interWAVE Communications, Inc.
 
312 Constitution Drive
 
Menlo Park, CA  94025
 
Phone: 650.838.2117
If the trouble is causing harm to the telephone network, the telephone company may request you to remove 
the equipment from the network until the problem is resolved.
It is recommended that the customer install an AC surge arrester in the AC outlet to which that device is 
connected. This is to avoid damaging the equipment caused by local lightning strikes and other electrical 
surges. 
This equipment uses the following USOC jacks and codes:
Note:
 This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference when the equipment is operated in a commercial environment. This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in 
a residential area is likely to cause harmful interference in which case the user will be required to correct the 
interference at his own expense.
Model Name
Facility Interface Code
Service Order Code
Jack Type
340122
04DU9-BN
6.ON
RJ-48C
340122
04DU9-DN
6.ON
RJ-48C
340122
04DU9-1KN
6.ON
RJ-48C
340122
04DU9-1SN
6.ON
RJ-48C
340122
04DU9-1ZN
6.ON
RJ-48C