Industrial Scientific Corporation RGX 사용자 설명서

 

30 

 

 
 

5 

Log into the RGX Configuration Interface 

On the computer, open a browser; into its address line type https:// 
followed by the unit's

 IP address

. If the unit IP address is unknown, 

use this value: 192.168.1.1. 
When prompted, enter the log-in credentials given below to access the 
RGX Configuration Interface: 
x  User name: RGXadmin (case sensitive) 

x 

Password: Unit 

activation code 

Note: It is recommended that the password be changed after initial log 
in. 

 

6 

Configure communication options  

 

Access Settings 
Review the RGX–iNet communications options: cellular, Wi-Fi, and 

Ethernet. 
x  Enable or disable each option. 

x  For each enabled option, enter, select, or edit the required values.  

Reminder: If your company’s wireless security network is “WPA2-
Enterprise”, the RGX Interface will require the upload of a certificate 

of authenticity that is 2048-bit or less and supplies the full chain of 
trust.  

Save and Reboot 
When finished, click on save; you will then be prompted to confirm the 
save.  
When prompted to reboot, simply click on the request, then confirmation. 
You do not need to do anything to the unit as the software will complete 

the reboot. 

 

7 

Status check  

 

 

Observe the board's LEDs inside the case and compare them to the 
"operational status" column in 

Table 3.5

 below. 

x  The LENS Wireless status light will be off until another equipment 

item joins the LENS group; otherwise, if there are no errors or 
connection issues, disconnect the Ethernet cable from the unit. 

x  If there are errors or issues, recheck the work completed to this 

point. If an issue persists, contact Industrial Scientific.  

x  Disconnect the cable from the computer and, as needed, 

reconfigure the computer to the desired network.  

 
 
 
 
 
 

Modified: 2018-05-25 13:18:14 EDT

Drawn By: Gaygan, Nancy

Created: 2018-05-16 10:24:51 EDT

Rev: 1

Printed By: Kuzmich, Bob

Int: 1.5

Date:May 29, 2018