Wavenet Technology Pty Ltd. BM3900M 사용자 설명서

Modem Test Jig ___________________________________________ Boomer-III User Manual & Integrator’s Guide

BM310012WT05

c. Press down the lock lever.

Note: If the cable has been partially inserted, or out of
alignment, the lock lever will not engage. Should this
occur, remove the cable (see below) and repeat steps
a-c.

Use the following procedure to remove the cable from the FPC
connector.

a. Lift up the lock lever of the FPC connector by flipping it

up with the nail of your thumb or index finger.

b. Remove the cable after the lock is released.

2. Install an antenna to the modem. Use either the on-board SMA

connection and an adapter cable between the modem MMCX
connector and the test jig SMA connector, or connect directly to
the modem itself.

3. Connect the PC serial cable to the DB9 connector marked

“PC”.

4. After making sure the power supply is set with the operating

voltage range of the modem switch the power supply on.

5. Select the DIP switch labelled H-P-ON to the ON position. The

green Power LED on the modem should illuminate.
You are now ready to communicate with the modem using the
PC as a host/terminal. The modem should be able to talk to the
PC by using Wavenet Commander software, or other modem
protocol software.

Lock Lever