Immanuel Electronics Co. Ltd. OF2P3UB 사용자 설명서
88
Q
When I try to change the system configuration to set the Authentication
Method to Fingerprint, a message is displayed indicating that 'There is a
user without a fingerprint registered. Cannot change Authentication
Method.'
Method to Fingerprint, a message is displayed indicating that 'There is a
user without a fingerprint registered. Cannot change Authentication
Method.'
A
The message implies that the user who installed the program (the initial
administrator) did not register a fingerprint. Once the program installer (the
initial administrator) registers his/her fingerprint, the message will not be
displayed when changing the authentication method.
administrator) did not register a fingerprint. Once the program installer (the
initial administrator) registers his/her fingerprint, the message will not be
displayed when changing the authentication method.
Q
The authentication method is set to Password, but I have forgotten my
password and cannot log on.
password and cannot log on.
A
You must have the Emergency Rescue Disk. Insert the disk when the
authentication screen is displayed to log on to your computer.
authentication screen is displayed to log on to your computer.
Q
What is the maximum number of users that can be registered?
A
There is no limit in the number of registered users.
Q
What is the administrator's security level setting?
A
It indicates the Fingerprint Authentication Level. Increasing the security level
will declare authentication successful only when there is a very high degree of
a fingerprint match.
Try decreasing the Security Level if your fingerprint is not vivid or requires
repeated registration attempts.
will declare authentication successful only when there is a very high degree of
a fingerprint match.
Try decreasing the Security Level if your fingerprint is not vivid or requires
repeated registration attempts.
Q
What operating systems are compatible with Ramses II?
A
Ramses II is compatible with Windows 98/98SE/ME.
Q
I have connected the fingerprint recognition sensor to my computer, but
the Hardware Installation Wizard does not run.
the Hardware Installation Wizard does not run.
A
Check your CMOS settings and verify whether the USB port is enabled.
If the Plug & Play feature does not function properly, even after enabling the
USB port, please contact our Customer Service.
If the Plug & Play feature does not function properly, even after enabling the
USB port, please contact our Customer Service.