u-blox Malmo AB 072002 사용자 설명서
Utfärdare / Issued by
Datum / Date
Beteckning / Ref.
Sida / Page
Mats Andersson
2005-03-30
cBProject-0503-17 (1)
21 (27)
Ärende / Subjekt
Godkänd av / Approved by
WCS Module User Manual
Template update: 00-12-01
4 Regulatory
4.1 FCC Compliance
4.1.1 FCC Statement
This device complies with RF-exposure evaluation for portable devices in FCC rules section 2.1093.
This device complies with RF-exposure evaluation for portable devices in FCC rules section 2.1093.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
connected
•
Consult the dealer or an experienced radio/TV technician for help
4.1.2 Labeling Requirements for End Product
For an end product using the OEM Serial Port Adapter or the OEM Bluetooth Enabler there must be a
label containing, at least, the following information:
For an end product using the OEM Serial Port Adapter or the OEM Bluetooth Enabler there must be a
label containing, at least, the following information:
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
inspection in compliance with the modular approval guidelines developed by the FCC.
Where the module will be installed in final products larger than 8 cm x 10 cm following statement has
to be placed ONTO the device.
“This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
to be placed ONTO the device.
“This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device contains
FCC ID PVH072002
FCC ID PVH072002