Wilson Electronics LLC 824WV 사용자 설명서

다운로드
페이지 12
Warnings and Recommendations
 Warning:  
In a wireless installation, do not plug the amplifier directly into 
the cell phone or cellular data card using an antenna adapter.  It 
will damage the cell phone or cellular data card.
 Warning: 
Do not install the inside antenna within four inches of metal.  
(Metal found inside the vehicle’s seat will not affect antenna 
performance.)
 Warning: 
Do not use any type of glass-mount antenna with this amplifier.  
The outside and inside antennas must be shielded from each 
other to prevent oscillation.
 Warning: 
Do not plug in the DC power supply until the outside and inside 
antenna cables are attached to the amplifier.
 Warning: 
RF Safety:  The inside antenna must be installed with a 
separation of at least eight inches from all persons and must not 
be located in conjunction with any other antenna or amplifier.
 Warning: 
RF Safety:  The outside antenna must be installed with a 
separation of at least 20 inches from any of the vehicle’s 
occupants or nearby persons and must not be located or 
operating in conjunction with any other antenna or amplifier.  
All roof-mount antennas should be centrally located on the 
roof of the vehicle.  Mirror-mount antennas should be at least 
six inches from the ground and leave at least 20 inches of 
separation from any persons near or around the vehicle.  Use 
of a cellular amplifier with an antenna gain higher than 5.12 dBi 
is in violation of FCC regulations for which the offender is fully 
liable.  All Wilson mobile antennas are 5.12 dBi or less in the 
800 MHz band.
Recommended amplifier installation locations are:
• 
Under the seat
• 
In the trunk
• 
Under the dash
Install the low-profile antenna 8-12 inches from where the cell phone or cellular 
data card will be used.
Power the amplifier through the ignition switch so the amplifier is turned on and 
off with the vehicle. 
If the vehicle has a sunroof, it is important to separate the inside and outside 
antennas by at least five feet. This prevents the amplifier from overloading or 
oscillating.