Wellink Corporation W202ER-4 사용자 설명서

45 

1.  If the LAN Configuration page is not already displaying, 

click the LAN tab. 

2.  In the USB Configuration table, enter the IP Address and 

Network Mask for the USB port. 

The IP address must place the USB port in the same subnet as 
the USB computer; If you are using both the LAN port and the 
USB port, however, the USB port and USB computer must not 
be in the same subnet as the LAN port or the computers 
attached to it. 

For example, you could assign the following IP addresses to 
the LAN ports (both assume a network mask of 255.255.255.0): 

10.0.0.2 10.0.0.x (x = 4-15) 

 

3. Click 

. 

 

If you are currently communicating with the device via the 
USB interface, then the connection will be terminated, 
because the IP address that the connection was using has 
now changed.

 

 If you are currently using the Ethernet interface, a page will 

display to confirm your change and your connection will 
remain active. 

4.  If necessary, reconfigure your USB PC so that its IP address 

places it in the same subnet as the new IP address of the 
USB port. See the Quick Start chapter, “Part 2 — 
Configuring Your Computers,” for instructions. 

5.  Log into Configuration Manager by typing the new LAN port 

IP address in your Web browser’s address/location box. 

6.  If the new settings work properly click 

 in 

the Save Setting tab. 

7. Click 

 to save your changes to permanent memory.