Netgear 05200007 사용자 설명서
NETGEAR VPN Client to NETGEAR FVL328 or FWAG114 VPN Router
D-1
202-10015-01
Appendix D
NETGEAR VPN Client
to NETGEAR FVL328 or FWAG114 VPN Router
Follow these procedures to configure a VPN tunnel from a NETGEAR ProSafe VPN Client to an
FVL328. This case study follows the VPN Consortium interoperability profile guidelines. The
configuration options for the FVS328 and FWAG114 are the same.
FVL328. This case study follows the VPN Consortium interoperability profile guidelines. The
configuration options for the FVS328 and FWAG114 are the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table D-1.
Summary
VPN Consortium Scenario:
Scenario 1
Type of VPN
PC/Client-to-Gateway
Security Scheme:
IKE with Preshared Secret/Key (not Certificate-based)
Date Tested:
November 2003
Model/Firmware Tested:
Gateway
NETGEAR FVL328 firmware v 1.4 or FWAG114 firmware v 2.1
Client
NETGEAR ProSafe VPN Client v10.1
IP Addressing:
Gateway Static
IP
address
Client Dynamic