Netgear 06200044 사용자 설명서

-2

Troubleshooting

Use the information below to solve common problems you may encounter. Also, please refer to the 
knowledge base on the NETGEAR Web site at 

.

This is because you have made changes to the settings and the Smart Wizard is offering you the 
chance to save the changes. If you want to avoid these Profile setting prompts, simply click Apply 
before you close the Smart Wizard.

You need to click the Initiate Ad Hoc button before you click Apply. Here is how you start an Ad 
Hoc network:

1. Fill in the Network Name (SSID).

2. Select the Computer-to-Computer (Ad Hoc) Network Type.

3. Click Initiate Ad Hoc.

4. Accept the default settings or make your changes and click OK

5. Click Apply.

During the WN311T software installation the wizard prompts you to choose either the NETGEAR 
Smart Wizard or the Windows configuration utility. Be sure the WN311T is properly installed in 
the PCI slot in the computer and follow these instructions to change your selection. 

1. Go to Control Panel and select Network Connections.

2. Right click on the connection and select Properties.

3. Click the Wireless Networks tab.

4. Select or clear the WN311T “Use Windows to configure my wireless network settings” check 

box.

Note: Be sure all computers in your Ad Hoc network are configured with static IP 

addresses in the same subnet.