Netgear 10400153 사용자 설명서

Troubleshooting

8-14

Make sure that the Enable Wireless Router Radio and Enable SSID Broadcast check boxes 

are selected.

Click Setup Access List.

Make sure that the Turn Access Control On check box is not selected.

Configure and test your wireless computer for wireless connectivity.
Program the wireless adapter of your computer to have the same SSID and channel that you 

specified in the router, and disable encryption. Check that your computer has a wireless link 

and can obtain an IP address by DHCP from the router.

Once your computer has basic wireless connectivity to the router, you can configure the advanced 

wireless security functions of the computer and router (for more information about security, see 

”).

You can restore the factory default configuration settings to reset the router’s user name to admin, 

the password to password, and the IP address to www.routerlogin.net. This procedure erases 

your current configuration, including your wireless security settings, and restores the factory 

defaults. 
You can erase the current configuration and restore factory defaults in two ways:
• Use the Erase function of the router (see 

• Use the restore factory settings button on the rear panel of the router. Use this method for cases 

when the administration password or IP address is not known.

To restore the factory default configuration settings when you do not know the administration 

password or IP address, you must use the restore settings button on the rear panel of the router.

Press and hold the restore settings button for 5 seconds.

Release the restore settings button, and wait for the router to reboot.

For more information about the factory default settings, see 

If the wireless router fails to restart, or the Power light continues to blink or turns solid amber, the 

unit might be defective. If the error persists, you might have a hardware problem and should 

contact Technical Support at