Netgear 12300211 사용자 설명서

The DGN2200v4 modem router is always in dual band concurrent mode, unless you turn off 
one radio.If you enable the wireless repeater in either radio band, the wireless base station or 
wireless repeater cannot be enabled in the other radio band. However, if you enable the 
wireless base station in either radio band and use the other radio band as a wireless modem 
router or wireless base station, dual band concurrent mode is not affected.

To set up a wireless network with WDS, both access points have to meet the following 
conditions:

Both access points have to use the same SSID, wireless channel, and encryption mode.

Both access points have to be on the same LAN IP subnet. That is, all of the access point 

LAN IP addresses are in the same network.

All LAN devices (wired and wireless computers) are configured to operate in the same 

LAN network address range as the access points.

Wireless Repeating Function 



Select Advanced > Advanced Setup > Wireless Repeating.

. Select this check box to use the 

wireless repeating function.

. If your modem router is the repeater, selecting 

this check box means that wireless clients cannot associate with it. Only LAN client 
associations are allowed.

If you are setting up a point-to-point bridge, select this check box. 

If you want all client traffic to go through the other access point (repeater with wireless 
client association), leave this check box cleared.

If you want all client traffic to go through the other access point (repeater with wireless 

client association), leave this check box cleared.

. If your modem router is the repeater, select this radio button.