Netgear fwag114 사용자 설명서

Troubleshooting

7-1

This chapter gives information about troubleshooting your Model FWAG114 Cable/DSL Wireless 
ProSafe Firewall . After each problem description, instructions are provided to help you diagnose 
and solve the problem.

After you turn on power to the router, the following sequence of events should occur:

1.

When power is first applied, verify that the Power LED

is on.

2.

After approximately 10 seconds, verify that:

a.

The Test LED is not lit.

b.

The LAN port LEDs are lit for any local ports that are connected.

c.

The WAN port LED is lit.

If a port’s LED is lit, a link has been established to the connected device. If a LAN port is 
connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the 
LED will be amber.

If any of these conditions does not occur, refer to the appropriate following section.

If the Power and other LEDs are off when your router is turned on:

•

Make sure that the power cord is properly connected to your router and that the power supply 
adapter is properly connected to a functioning power outlet. 

•

Check that you are using the 7.5 V DC power adapter supplied by NETGEAR for this product.