Netgear WG111V2 사용자 설명서

iii

Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used 
near a radio or TV receiver, it may become the cause of radio interference. Read instructions for correct handling.

This product does not contain any user serviceable components and is to be used with approved antennas 
only. Any product changes or modifications will invalidate all applicable regulatory certifications and 
approvals

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment 
should be installed and operated with minimum distance of 20 cm between the radiator and your body. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter." 

We NETGEAR, Inc., 4500 Great America Parkway, Santa Clara, CA 95054, declare under our sole responsibility that 
the model WG111 Cardbus Card Wireless Adapter complies with Part 15 of FCC Rules. Operation is subject to the 
following two conditions:

•

This device may not cause harmful interference, and

•

This device must accept any interference received, including interference that may cause undesired operation.

This section includes user requirements for operating this product in accordance with National laws for usage of radio 
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result 
in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.

NOTE:

This product's firmware limits operation to only the channels allowed in a particular Region or Country.  
Therefore, all options described in this user's guide may not be available in your version of the product.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following methods:

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and the receiver

•

Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected