Netgear WG111V2 사용자 설명서

Basic Setup

3-15

If you have problems connected to your wireless network, try the tips below.

1.

Question:  The product literature says the WG111 can operate at 54 Mbps. Why do I see no 
more than 11 Mbps speed on my WG111 Smart Configuration Utility status line?

Answer:  If you are connecting to an 802.11b network, the maximum 802.11b speed is 11 
Mbps. 

2.

Question:  The product literature says the WG111 can operate at 54 Mbps. Why do I see no 
more than 14 Mbps speed on my WG111?

The LED is not 
lit.

The WG111 is not 
connected to the 
USB port 
properly or the 
WG111 software 
is not loaded. 

Remove and reinsert the WG111.

Check the Windows device manager to see if the WG111 
is recognized and enabled. Reload the WG111 software, 
if necessary.

Try to install the WG111 in a different USB slot on your 
system if one is available.

The wireless 
LED blinks and 
cannot connect 
to an access 
point. 

The WG111 is 
attempting to 
connect to an 
access point, but 
cannot connect. 

The access point may not be powered on. Or, the access 
point and the WG111 are not configured with the same 
wireless parameters. Check the SSID and WEP settings.

I can connect to 
an access point, 
but I cannot 
connect to 
other 
computers on 
the network or 
the Internet.

This could be a 
physical layer 
problem or a 
network 
configuration 
problem.

Check to make sure that the access point is physically 
connected to the Ethernet network.

Make sure that the IP addresses and the Windows 
networking parameters are all configured correctly.

Restart the cable or DSL modem, router, access point, 
and notebook PC.

Refer to the 

 for additional suggestions.