Netgear WG602v3 사용자 설명서

다운로드
페이지 118
User’s Guide for the WG602 54 Mbps Wireless Access Point
3-5
Basic Installation and Configuration
 
Installing the 54 Mbps Wireless Access Point WG602 v
3
Follow the instructions below to set up and test basic wireless connectivity. Once you have 
established basic wireless connectivity, you can enable security settings and configure the 
advanced wireless functions.
Before installing the 54 Mbps Wireless Access Point WG602 v3, you should make sure that your 
Ethernet network is up and working. You will be connecting the access point to the Ethernet 
network so that computers with 802.11b or 802.11g wireless adapters will be able to communicate 
with computers on the Ethernet network. In order for this to work correctly, verify that you have 
met all of the system requirements, shown on 
1 S
ET
 
UP
 
THE
 WG602 
V
3
 A
CCESS
 P
OINT
Tip: Before mounting the WG602 v3 in a high location, first set up and test the WG602 v3 to 
verify wireless network connectivity.
a.
Prepare a PC with an Ethernet adapter. If this PC is already part of your network, record its 
TCP/IP configuration settings. 
b.
Configure the PC with a static IP address of 192.168.0.210 and 255.255.255.0 for the 
Subnet Mask. 
c. 
Connect an Ethernet cable from the WG602 v3 to the PC (A)
Figure 3-2: Set up the WG602 v
3
d. 
Turn on your computer, connect the power adapter to the WG602 v3 and verify the 
following:
 The power light goes on. 
 The LAN light of the wireless access point is lit when connected to a powered on PC.
WG602 54 Mbps
Wireless Access Point
E T H E R N E T
A