Netgear WGPS606 사용자 설명서
Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch
Basic Installation and Configuration
3-11
Draft 1, 01 Feb 05
Using the IP Settings Options
The IP Settings page is under the Setup heading of the main menu. Use this page to configure
static IP addresses.
static IP addresses.
Figure 3-6: Basic IP Settings page
•
The IP Address Source
The wireless access point is shipped preconfigured to use a private IP address on the LAN
side, and to act as a DHCP client. If the wireless access point does not find a DHCP server on
the Ethernet LAN, it defaults to this IP configuration:
side, and to act as a DHCP client. If the wireless access point does not find a DHCP server on
the Ethernet LAN, it defaults to this IP configuration:
–
IP Address — 192.168.0.201
–
IP Subnet Mask — 255.255.255.0
If your network has a requirement to use a different IP addressing scheme, you can make those
changes in this page.
changes in this page.
•
WGPS606 Name (NetBIOS)
You can change the access point name after the initial configuration. Enter a new name for the
wireless USB print server and click Apply to save your changes.
wireless USB print server and click Apply to save your changes.
Remember to click Apply to save your changes.