AeroScout EX5200 사용자 설명서
EX5200 Exciter Deployment Guide
13
Direct Power Supply
To connect to the power supply, connect a 110/220 VAC to 48 VDC power
adapter to the Exciter’s power jack.
Figure 5: 110/220 VAC to 48 VDC Adapter
Note
The EX5200 requires approximately 6W of power. When connecting an
Exciter to a direct power source, verify that the power level is sufficient.
When using a direct power source for chaining, you can only power up to
two Exciters sequentially, even if the power source is sufficient for more.
two Exciters sequentially, even if the power source is sufficient for more.
Exciters must only be powered by a limited (marked LPS or NEC class 2)
power supply.
power supply.
PoE Switch
If your network has a Power-over-Ethernet infrastructure, you can connect a
CAT-5/6 Ethernet cable from the PoE switch to the Exciter’s LAN connector. This
CAT-5/6 Ethernet cable from the PoE switch to the Exciter’s LAN connector. This
supplies both the power and the network connection.
Note
PoE standard 802.3af class 0 allows power for a single EX5200 Exciter.
When using PoE with the other chained Exciters, a PoE connection must be
made to every second Exciter in the chain. In addition, the LAN connectivity
that the PoE supplies is not used for slave Exciters in a chain. Slave Exciters
receive data from the Master Exciter via the Chain IN connection.
that the PoE supplies is not used for slave Exciters in a chain. Slave Exciters
receive data from the Master Exciter via the Chain IN connection.